![]() ![]() So yes, an active mic-splitter is the ideal and preferred solution, if possible. In practice, the manufacturers use transformers designed to make sure this isn’t a significant problem, but loading losses can build up if there are a lot of split outputs and the destinations have low input impedances. The impedance seen by the mic is that of the transformer’s input impedance, but also affected by the ‘reflected impedances’ of the combination of destination impedances, as determined by the winding ratios of the transformer. The impedance issue is still unpredictable, but to a far smaller extent. ![]() A good mic-split transformer will have multiple Faraday shields to minimise any risk of mutual interference, and good magnetic screening too. All but one of the outputs are usually floating, so that removes the risk of ground-loop problems too. ![]() In general only one of the splitter outputs is allowed to pass phantom power to the input, so that solves the multiple phantom power-source problem straight away. There is also the confusion over paralleled phantom-power supplies and equipment ground loops, potentially causing interference issues as well.Ī passive transformer splitter, on the other hand, is a traditional and much safer situation. (Halved for two destinations, a third for three, and so on.) The resulting very low input impedance seen by the mic is likely to result in severe headroom and transient distortion issues, as well as a low output level caused by the ‘loading losses’. In this situation, the load impedance seen by the mic is the parallel addition of all the destination input impedances, which will inherently be a lot lower than a conventional single mic input. The first, cheapest and nastiest - and the type Schoeps are particularly concerned about - is a simple parallel wiring of an input XLR to a bunch of output XLRs. There are two kinds of passive splitters. Bear in mind that splitters are generally specified for live-sound situations, where the ultimate in preamp quality is rarely expected (or needed). The potential downside is that the preamp in a splitter may not reach the standards expected of a high-end preamp, especially in terms of equivalent input noise. This allows the mic to work as intended and avoids ‘loading losses’. The output of the mic preamp is distributed by whatever means to feed the multiple outputs - but the mic ‘sees’ none of that it’s only concerned with feeding its individual mic input stage. ![]() SOS Technical Editor Hugh Robjohns replies: In an active splitter, the mic feeds a single mic preamp and is powered in the conventional way. The manual for my Schoeps CMC65 mic cautions: “If one microphone must be connected to multiple inputs simultaneously, an active microphone splitter should be used in order to preserve the loading and powering conditions for the microphone and to prevent interference.” Should I ignore this at my peril? The Schoeps manual warns of the evils of passive mic splitters for a good reason - but the ART S8 and similar single-split transformer devices shouldn’t pose a problem. I use an ART S8 eight-channel mic splitter, a passive device, to send mic signals to two separate recording systems (a Focusrite 828 preamp paired with an RME UFX interface, and an Audient ASP800 preamp paired with a Focusrite 18i20 interface). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |